Saturday, July 13, 2013

ACER S200 Hard Reset

ACER S200 Hard Reset

Before you buy a new cell phone or new tablet, please try the following procedure to repair your device. First charge your battery, backup your important data if possible and in most cases take out SIM and SD card. It is impossible to recover your data after doing a hard reset, so online backup is always important. For all of your data, a backup should be done on an external device, hard drive, raid system or media.


Acer Tempo S200 hard reset

ACER S200 hard reset

Acer S200 hard reset with buttons / keys


If your screen is not responding to stylus input: Hold the Volume up and Volume down buttons while pressing reset until the screen shows “Clean Boot”.

Resetting your Acer S200 smartphone

You may have to perform a reset if your smartphone fails to respond when buttons are pressed or the screen is tapped.
Note: Before performing a reset, ensure that your smartphone is
not locked. Press any key or tap the screen to see if the phone
responds.

Reset

A reset will clear the RAM of your smartphone. It is similar to turning a computer off and then turning it back on.

Important: To reduce risking damage to your smartphone, only use the supplied stylus to reset the device.

Use the tip of your stylus to lightly press the Reset button inside the hole on the side of your smartphone.

Clean boot

Warning! You should only perform a clean boot when all other
reset options have failed to restore your smartphone to an operational
state.

A clean boot will restore your smartphone to the state it was when you got it from the factory.

Warning!

This will erase all your personal information, any contacts stored on your smartphone and any programs you installed.

If your screen is responding to stylus input: Go to Start > Utilities > Default Settings. Read the warning information and enter the security code in the empty textbox. Tap OK to proceed.

Acer S200 hard reset with buttons / keys


If your screen is not responding to stylus input: Hold the Volume up and Volume down buttons while pressing reset until the screen shows “Clean Boot”.

No comments:

Post a Comment